Question |
| Asked by: |
Ted Pittman |
| Subject: |
GammaMax Pulley system |
| Question: |
· The engine is connected to four chains which are connected to one chain.
· That chain is connected to a hook and a poly-cord (= Non-stretchable).
· The cord goes over a skateboard wheel ( which can rotate very freely).
· The cord goes to a second wheel and down through three rigid wires to a bucket of sand+.
· The weight of the bucket of sand (and support wires) matches the weight of the engine (+ chains).
Video at: http://www.youtube.com/watch?v=vuKdwtQhqOk
|
| Date: |
9 September 2013
|
| report abuse
|
|
Answers (Ordered by Date)
|
| Answer: |
Ted Pittman - 26/11/2013 22:09:31
|
| | Many thanks to Sandy Kidd for info on how to make a Pulley System work properly.
|
| Report Abuse |
| Answer: |
Nitro - 27/11/2013 23:28:29
|
| | Dear Ted,
I am sorry but I cannot understand. What exactly is it that you think this video shows?
regards
NM
|
| Report Abuse |
| Answer: |
Ted Pittman - 28/11/2013 08:34:54
|
| | It shows the top of a Gamma Drive device on one end and a bucket of sand on the other end.
The device + chains weighs exactly the same as the bucket of sand and its support wires.
For other views of the project, search GAMMAMAX on YouTube.
|
| Report Abuse |
| Answer: |
Ted Pittman - 14/12/2014 14:28:47
|
| | A closer look.
https://www.youtube.com/watch?v=3rNope82fOI
|
| Report Abuse |
| Add an Answer >> |
